The GearTree 2742 Single-Point Mounting Ring Clamp to Stand features a single 16mm spigot receiver, to enable you to mount any of the Geartree Accessory Arms to any of the stands in the . With a High-Torsional Strength of 50N.m, enabling it to hold the weight of multiple accessory arms in the GEARTREE System. It can be used with either the Geartree Floor-To-Ceiling stand, the Greatree Desk-Stand or the Geartree Professional Boom Stand, for virtually limitless mounting possibilities.

High-Torsional Single-Point Mounting Clamp

Made from high-strength Aluminium alloy, GEARTREE 2472 Single-Point Mounting Clamp has a super-high torsional strength of 50N.m, enabling it to withstand the weight of the arm and accessories with the greatest of ease.

Geartree 2742 Single-Point Mounting Ring Clamp

It comes with a set of wear-resistant POM rings, enabling the clamp to be adapted for use with poles of 42mm, 40mm, and 35mm, through the use of different washers.  Or adapters to fit 1.65, 1.57, and 1.38" diameters of round pipe.

The Geartree 2472 Single-Point Mounting Clamp Stand is the glue that holds all the GEARTREE stands and accessories together. It enables you to mount any of the GEARTREE Accessory arms to either the GEARTREE Floor-To-Ceiling stand, the GEARTREE Desk-Stand or the GEARTREE Professional Boom Stand. An essential accessory for owners of the GEARTREE studio grip system. 

Instructions

Put the gasket into the inner wall of the clamp
Wrap around the stand with the clamp
 Check if the gasket is at the center of the clamp’s inner wall.
Insert the quick release knob’s screw into the hole while keeping know downwards.Turn the knob clockwise about 90 degrees, and press it down to lock.

Package Contents:
1x  Mount Ring
2x 42mm Gasket
2x 40mm Gasket
2x35mm Gasket
1x Quick-release Knob
1x Locking Screw
1x Jack Bolt
1x H3 Hex key 
2x Magic Strap

Note:
Remove all loads from the arm before installing, removing or adjusting the clamp.